LIU Ji-yuan
,
ZHANG Zi-cheng
,
ZHU Fu-xian
,
LI Yan-mei
,
Manabe Ken-ichi
钢铁研究学报(英文版)
The controlled cooling technology following hot rolling process is a vital factor that affects the final microstructure and mechanical properties of the hot-rolled transformation induced plasticity (TRIP) steels. In the present study, low alloy C-Si-Mn TRIP steel was successfully fabricated by hot rolling process with a 450 hot rolling mill. To maximize the volume fraction and stability of retained austenite of the steel, two different cooling methods (air-cooling and ultra-fast cooling “AC-UFC” and ultra-fast cooling, air-cooling and ultra-fast cooling “UFC-AC-UFC”) were conducted. The effects of the cooling method on the microstructure of hot-rolled TRIP steel were investigated via optical microscope, transmission electron microscope and conversion electron Mssbauer spectroscope. The mechanical properties of the steel were also evaluated by conventional tensile test. The results indicated that ferrite and bainite in the microstructure were refined with the cooling method of UFC-AC-UFC. The morphology of retained austenite was also changed from small islands distributing in bainite district (obtained with AC-UFC) to granular shape locating at the triple junction of the ferrite grain boundaries (obtained with UFC-AC-UFC). As a result, the TRIP steel with a content of retained austenite of 1152%, total elongation of 32% and product of tensile strength and total elongation of 27552 MPa·% was obtained.
关键词:
hot-rolled TRIP steel
,
retained austenite
,
TRIP effect
,
Mssbauer spectra
,
mechanical property
ZHENG Dong-sheng
,
ZHU Fu-xian
,
LI Yan-mei
,
CHEN Bing-zhang
钢铁研究学报(英文版)
The effect of the run-out table cooling patterns on the microstructure and mechanical properties of Nb microalloyed steel plates was investigated by hot rolling experiment. The results showed that the mixed microstructure containing ferrite, bainite and significant amounts of retained austenite can be obtained through three kinds of cooling patterns on the run-out table under the same hot rolling condition. Three kinds of cooling patterns possess different austenite transformation kinetics, which leads to variations in microconstituent characteristics. The yield strength increases, the tensile strength decreases and the total elongation tends to increase as the cooling patterns Ⅰ, Ⅱ and Ⅲ were applied respectively. The yield strength, the total elongation and the product of tensile strength and ductility reach the maximum values (547 MPa, 37.2% and 28384 MPa·%, respectively) for the steel plate processed by cooling pattern Ⅲ.
关键词:
Nb microalloyed steel
,
hot-rolled multiphase steel
,
cooling pattern
,
microstructure
,
mechanical property
ZHANG Ming-ya
,
ZHU Fu-xian
,
ZHENG Dong-sheng
钢铁研究学报(英文版)
Through the comparison of microstructure for polygonal ferrite (PF) matrix transformation induced plasticity (TRIP) seamless steel tube at different positions before and after tensile rupture, the transformation behavior of retained austenite (RA) was studied. The results showed that there were no yield points in tensile process and the splendid elongation and tensile strength were contributed by the uniform ferrite/bainite grains and the transformation of RA. The stability of RA was to some extent in inverse proportion with the ability of transformation induced plasticity. The coarse retained austenite located in ferrite and ferrite/bainite laths were all transformed into martensite during the tensile process.
关键词:
TRIP steel
,
retained austenite
,
austempering
,
heat treatment
